Kenwood TM-V7E - Manual (Page 40)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
34
■ Changing Call Channel Contents (Split)
1 Select the desired band.
2 Select the desired receive frequency and related
data (Tone, CTCSS, DTSS, etc.) using VFO mode or
Memory Recall {page 31}.
3 Press [F], [CALL] (1 s).
• "±" appears.
• The channel number is visible if using Memory Recall
mode in step 1.
4 Turn the Tuning control, or press Mic [UP]/[DWN],
to select the desired transmit frequency.
5 Press [CALL] again.
• The selected transmit frequency is stored in the Call
channel, and the previous mode is restored.
Note:
◆ Transmit Offset status and Reverse status are not stored in a split
Call channel.
◆ Lockout status is not copied from a memory channel to the Call
channel.
MEMORY a VFO TRANSFER
Transferring the contents of a memory channel or the Call
channel to the VFO can be useful if you want to search for
other stations or a clear frequency, near the selected
memory channel or Call channel frequency.
1 Recall the desired memory channel or the Call channel.
2 Press [F], [VFO].
• The complete contents of the memory channel or the Call
channel are copied to the VFO. VFO mode is selected
after the transfer is completed.
Note: A transmit frequency from a split memory channel or split Call
channel is not transferred to the VFO. To transfer a transmit frequency,
press [REV], then press [F], [VFO].
CHANNEL DISPLAY FUNCTION
When this function is switched ON, the transceiver displays
only memory channel numbers instead of frequencies.
Press [LOW]+[ ] to toggle this function ON or OFF.
VOL SQL
CALL CALL
1
2