Kenwood TM-V7E - Manual (Page 53)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
47
■ Using Program Scan
1 Select a frequency equal to or between the
programmed scan limits.
2 Press [VFO] (1 s).
• The 1 MHz decimal blinks while scanning is in
progress.
• Scan starts at the frequency currently displayed.
3 To reverse the scan direction, turn the Tuning
control or press Mic [UP]/[DWN].
• Upward scan:
Turn the Tuning control clockwise or press Mic [UP].
• Downward scan:
Turn the Tuning control counterclockwise or press Mic
[DWN].
4 To quit Program Scan, press [BAND SEL] for the
band being scanned or [VFO].
• When scanning the TX band, you can also press Mic
[PTT] to quit Scan.
Note:
◆ The squelch must be closed for Scan to function.
◆ If the frequency step of the current VFO frequency differs from
the frequency step of the programmed frequencies, you cannot
use Program Scan.
◆ If the frequency step of the lower limit and upper limit differ, you
cannot use Program Scan.
◆ If the current VFO frequency is within more than one scan range,
Scan starts with the range stored in smaller channel numbers.
MHz SCAN
MHz Scan allows you to scan a 1 MHz segment of the
band. The current 1 MHz digit determines the limits of the
scan. For example, if the current frequency is 438.400
MHz, then MHz Scan would scan from 438.000 MHz to
438.975 MHz. The exact upper limit depends on the step
size selected.
1 Select the desired band.
2 Start VFO Scan or Program Scan first.
3 Press [MHz] to start MHz Scan.
4 To quit MHz Scan, press [MHz] again.
• If the current frequency is within the program scan range
when stopping MHz Scan, Program Scan resumes.
Otherwise, VFO Scan resumes.