Kenwood TM-V7E - Manual (Page 42)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
36
PROGRAMMABLE MEMORY (PM)
Programmable Memory (PM) allows you to store virtually
all settings currently set on the transceiver. So you can
quickly recall exactly the same environment later. This
transceiver provides 4 PM channels. If you are the type
who likes the many features offered by modern
transceivers, but dislikes remembering how to make all the
necessary settings, you will find Programmable Memory
particularly useful.
PROGRAMMABLE INFORMATION
The following programmable settings are shared by the
VHF and UHF bands:
The following settings can be separately stored for the VHF
and UHF bands:
TX band
Automatic Power Off
Time-Out Timer
Auto Dimmer Change
Positive/ Negative Reversal
Transfer rate
1750 Hz tone transmit hold
(TM-V7E only)
Control band
Automatic Band Change
Display Dimmer
Display contrast
Beep volume
DTSS/Page code transmit delay
Microphone keypad
confirmation tone
VFO frequency
Memory Recall mode
TX band
Frequency step
Tone frequency
Tone status
Offset direction
Automatic Repeater Offset
Upper frequency limit
(for Programmable VFO)
Scan resume method
Automatic Simplex Checker
DTSS/Page status
Page code memory
channels
VFO mode
Call Channel mode
Control band
Transmit output power
CTCSS frequency
CTCSS status
Offset status
Reverse status
Lower frequency limit
(for Programmable VFO)
S-meter Squelch
Advanced Intercept Point
DTSS code
Dual Band RX