Kenwood TM-V7E - Manual (Page 56)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
50
DUAL TONE SQUELCH SYSTEM (DTSS)
DTSS provides a more refined method than CTCSS to
selectively communicate with specific stations. The squelch
on the transceiver opens only when the same 3-digit DTMF
(Dual Tone Multi-Frequency) code is received that is
programmed in this transceiver. You can select a 3-digit
code from among 1000 combinations, 000 to 999.
Note:
◆ Be aware that audible DTMF tones from other transceivers near you
may be picked up by your MC-53DM or MC-45 microphone. If so,
this could prevent the functions described in this chapter from working
correctly.
◆ DTSS does not function while you are storing DTSS codes even if a
code is received that matches one already stored in memory.
STORING DTSS CODES
1 Select the desired band.
2 Press [F], [DTSS] to switch the DTSS function ON.
• "DT" appears.
3 Press [F] (1 s), [C.SEL].
• The current DTSS code appears with the first digit
blinking. The default is 000.
4 Use the Tuning control or Mic [UP]/[DWN] to select the
first digit.
• When using the MC-53DM microphone, you can select
three digits by simply pressing numeric keys in sequence.
5 Press [ s s s s s ] .
• The second digit blinks.
6 Repeat Steps 4 and 5 to select the second and third
digits.
7 To switch the DTSS function OFF, repeat pressing [F],
[DTSS]
twice.
Note: The selected DTSS code also can be stored in a memory channel
or the Call channel.
1
1