Kenwood TM-V7E - Manual (Page 72)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
66
CHANGING BEEP VOLUME
The transceiver beeps each time you press a button or a
microphone key. You can change the beep volume or turn
it off.
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 14 (Audio).
3 Press [ s s s s s ] , then select Item No. 1 (Beep Volume).
4 Press [SET], then select the volume from level 1 (min.)
to 7 (max.) and OFF. The default is level 5.
5 Press [MNU] again to exit Menu mode.
CHANGING MULTI-FUNCTION BUTTON LABELS
This transceiver shows button labels on the lower portion of
the display. You can also change the default configuration
to one of the following types. Select the configuration
depending on which functions you use most frequently.
Basic State Display Labels Labels after Pressing [F]
[F] [TONE] [DTSS] [LOW] [OFF] [SHIFT] [REV] [VISUAL]
or
Basic State Display Labels Labels after Pressing [F]
[F] [VISUAL] [REV] [LOW] [OFF] [TONE] [SHIFT] [DTSS]
Note:
◆ The labels that appear after pressing [F] (1 s) are identical no matter
which configuration you select.
◆ After selecting the F/TONE/DTSS/LOW configuration, press
[F]
, [REV] (1 s) to activate ASC {page 27} and press [F], [REV] to
cancel the function.
◆ After selecting the F/VISUAL/REV/LOW configuration, press
[F]
, [TONE] (1 s) to activate Automatic Tone Frequency ID {page 49}
and press any key to cancel the function.
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 2 (Front Panel).
3 Press [
s s s s s ] , then select Item No. 3.
4 Press [SET] repeatedly until the desired configuration
appears.
5 Press [MNU] again to exit Menu mode.
VOL SQL
CALL CALL
1
2
VOL SQL
CALL CALL
2
VOL SQL
CALL CALL
1
2
VOL SQL
CALL CALL
1
2