Kodak PROFESSIONAL LED II 20P User Manual
Page 95
Diagnostics and Troubleshooting
September 2000
5-5
15
timers busy
A low level motor move command
was issued while the timer motor
was in use.
Wait for the motor move to complete
or stop the motor and reissue the
command.
16
timer spurious interrupt
code
A spurious (false) timer interrupt
has occurred.
No solution required.
17
command not
implemented
The function requested is not
supported in this software release.
No solution required.
18
unexpected OCP reply
The 300 board sent an unexpected
message to the 200 board.
Call for service.
20
pec service mode
The service switch for the 200
board is on, enabling on-board
LEDs that can cause fogging.
Call for service.
21
opc service mode
The service switch for the 300
board is on, enabling on-board
LEDs that can cause fogging.
Call for service.
22
end of roll, remove
paper at sht xprt
The paper cassette is empty and
tail of the paper has been fed into
the sheet transport area.
Pull the paper tail out of the sheet
transport area near the knife.
23
in error state
A previous error has not been
cleared.
Reinitialize the printer.
24
middle of load
Attempting to perform a function
while paper is being loaded.
Wait until paper loading is complete
and perform the function again.
25
wait proc
Attempting to perform a function
while the printer detects a problem
with the processor.
Turn on the processor. Wait for the
processor to warm up and then
reinitialize the printer.
26
xport back door open
The back sheet transport door was
left open.
Close the back sheet transport door.
27
xport front door open
The front sheet transport door was
left open.
Close the front sheet transport door.
28
unit does not fit
The sum of all the unit setups since
the last print start exceeds 33
inches.
Begin printing.
29
sheet fogged in sheet
xport
A door was opened while sending a
sheet from the printer to the
processor.
Reprint.
30
unexpected knife
neither limit
Knife not detected at either end.
Call for service.
31
door opened briefly
The door was opened and closed.
Reinitialize the printer.
64
bad msg checksum
A problem with a prom has
occurred.
Call for service.
Error
Code
Error Message
Possible Cause
Possible Solution