Kodak PROFESSIONAL LED II 20P - Manual (Page 22)

Using the System
2-2 September 2000
WARNING: When handling or mixing chemical solutions, wear protective
eyewear, clothing, and gloves. For safe handing practices with
all chemicals, refer to the MSDS information.
3. Check that the chemistry in each processor tank is at the top of the overflow
pipe. If necessary, add warm water to reach the correct level.
CAUTION: Use water to top off the chemical tanks. Do not use replenisher
chemistry.
4. After the temperature is up to the correct level, operate the main drive for
30 minutes. See “Controlling the Processor Drive” on page 3-39.
5. Process a control strip. See “Processing a Control Strip” on page 3-32.
Starting up the Printer
1. Verify that the processor is on, up to the correct temperature, and in control.
2. If needed, turn the circuit breaker on the back of the printer on.
When the Power and Standby LEDs on the OCP are illuminated, press the
Start key on the OCP to begin printer initialization.
If paper is loaded, when initialization is complete (in 3 to 4 minutes) the
message “
Status: ON LINE - Ready ” appears on the OCP. Startup is
complete and the printer is ready to print. Turn the computer on; then go to
the next page and calibrate the printer.
If paper is not loaded, the message “ Out of paper, open supply door
to load ” appears on the OCP. Do the procedures below.
• “Loading Paper Into the Supply Cassette” on page 3-6.
• “Installing the Supply Cassette” on page 3-10.
When “ On-line and Ready ” is displayed, turn the host computer on. Go to
the next page and calibrate the printer.
overflow
pipe