Accessing the printer features, Shutdown and restart, Shutdown – Kodak PROFESSIONAL LED II 20P User Manual
Page 47: Restart, Unload supply, Selecting scsi ports, Accessing the printer features -15, Shutdown and restart -15, Shutdown -15 restart -15, Unload supply -15
System Operating Procedures
September 2000
3-15
Accessing the Printer Features
Shutdown and Restart
Shutdown
1.
Select “Shutdown” from the main menu on the OCP.
2. Select
“Shutdown NOW?”
This causes the printer to shut down operations and enter the standby mode.
Restart
1.
Select “Restart” from the main menu on the OCP.
2. Select
“Restart NOW?”
This causes the printer to immediately shutdown operations and reboot.
IMPORTANT: This shutdown is not a soft shutdown and does not save the
parameter settings that have been made since the previous
startup. Also, using this feature may cause a black line on the
paper in the shoe.
Unload Supply
1.
Select “Unload Supply” from the main menu.
2. Select
“Unload Supply NOW?”
The printer enters its unload paper sequence. When the unload paper
sequence is complete, the OCP returns to the main menu.
3. Select
“Exit” to return to the OCP display. You are prompted to load another
roll of paper into the printer.
Selecting SCSI Ports
1.
Select “Setup” from the main menu on the OCP.
2. Select
“Ports”.
3. Select
“SCSI”.
4. Select
“SCSI Target ID”.
5. Use
the
Up and Down Arrows to select a new SCSI ID. The allowable SCSI
IDs are 0, 1, 2, 3, 4, 5, 6, 7.
6. Press
Select to select/set the new value.
7. Select
“Exit” to return to the previous menu on the OCP.