Kodak PROFESSIONAL LED II 20P - Manual (Page 60)

System Operating Procedures
3-28 September 2000
Status Messages
Status messages display on the LCD display of the operator control panel to
indicate the status or current state of the processor.
Drive Key and
Drive Light Pressing Drive accesses the drive motor control system. The light
above the key illuminates when the Drive key is active.
Material Key and
Material Light The Material key is used to access the Material Transport screen.
The Material key can also be used to view the processor setup
parameters, select the control strip screen, and start the control strip
procedure (see “Processing a Control Strip” on page 3-32). The light
above the Material key illuminates when the Material Transport
screen is active. If paper is present at the feed table, the LCD
display on the OCP indicates the size of the paper currently at the
entrance of the processor or at the exit. For example:
NOTE: Moving dots illuminate under the size indicators to indicate
that paper is moving through the processor.
Reset Keys The Reset keys are the two embossed unmarked keys below the
Power and Material keys. Pressing both Reset keys simultaneously
puts the processor in Reset mode.
Key/Light
Key /LED
Indicator Light
Description/Function