Kenwood XD-980MD - Manual (Page 68)

XD-980MD (En)
6 8
Preparation section
Basic section
Application section
Knowledge sections
Adjust the clock before setting the timer.
Timer operation
Enter the figure of minute.
Enter the figure of hour.
Activate the clock adjustment mode.
Clock adjustment
When the AC cord is connected to a receptacle, the clock
display starts to flash. Set the correct time following the
instructions.
1
1
÷ The time of the day is represented in 12-hour AM/PM method.
÷
Press the ENTER key. The hour is entered and the minute
display starts to blink.
2
2
Ensure that the unit is OFF.
1
2
3
Example: Adjustment to 8:45
÷
The time display starts to blink.
÷ If you make a mistake, restart from the beginning.
÷
To adjust correct time, press the ENTER key at the same
moment as a time announcement.
÷ The time display flashes when a power failure has occurred or
when the power plug has been pulled and inserted again. In
such a case, set the clock again.
To decrease
the figure To increase
the figure
To decrease
the figure To increase
the figure
Time display is made only when the unit is switched off.
AUTO
ENTER
ENTER
A M 8 4 5 :
A M 8 ) ) :
A M 1 2 ) ) :
D
O W
N
UP MULTI CONTROL
/VOLUME
D O W
N
UP MULTI CONTROL
/VOLUME