Kenwood XD-980MD - Manual (Page 15)

XD-980MD (En)
1 5
Preparation section
Basic
section
Application section
Knowledge sections
Controls and indicators
Operation
Loading batteries
2 Insert batteries. 3 Close the cover.
÷
When pressing more than one remote control keys successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
After plugging the power cord of this unit, press the ON/
STANDBY ( ) key of the remote control unit to turn the
system ON. When the system is turned ON, press the key
of the function to be operated.
Press the ON/STANDBY ( ) key again for OFF. Only the
time display will remain lit and standby status will be
reached.
1. The provided batteries are intended for use in operation checking, and their service life may be short.
2. When the remote controllable distance becomes short, replace both of the batteries with new ones.
3. If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote sensor, malfunction may occur.
In such a case, change the installation position to avoid malfunction.
1 Remove the cover.
÷
Insert two R6 (“AA”-size) batteries following the polarity indications.
Operation of remote control unit
Notes Notes
Remote sensor
Model: RC-H9R
Infrared ray system
Operating range (approx.)
6 m
2
1
9 9
( (
(
9
9
(
30 ° 30 °