KORG OASYS musical instruments - Manual (Page 134)

Sampling (Open Sampling System)
126
Using the metronome
It is convenient to use the metronome when you want
to play a program or combination at a specific tempo
and sample your performance.
You can make metronome settings in Metronome
Setup, in Program or Combination P0: Play– Audio
Input/Sampling. You might find it convenient to set
“Bus (OUTPUT) Select” to one of the Indiv. 1–8
outputs, connect the (INDIVIDUAL) 1–8 jacks to a
mixer, and monitor the metronome via your mixer.
Automatically setting-up for the desired
sampling method (Auto Sampling Setup)
In each mode, Auto Sampling Setup automatically
makes the appropriate settings for the sampling-
related parameters. For example in Program mode you
can use this to make the necessary settings for
resampling your playing on a program, or to make
settings for sampling only an external audio source
while you monitor your playing on a program.
However, these automatic settings assume typical
situations, so you’ll need to adjust the parameters to
meet your situation.
This function is available in the following pages:
Sampling and editing in Sampling mode
In Sampling mode, you can record samples, and edit
sample data that you sampled or loaded from media
(including WAVE and AIFF formats). You can also
assign the edited samples to indexes (zones) to create a
multisample.
Sampling mode page structure
For details on how to access each mode and page, refer
to “Basic operations” on page 34.
Sampling can be performed in any page P0–P9 of
Sampling mode by using the REC/WRITE switch and
the START/STOP switch. Recording-related settings
such as input level are made by the parameters of P0:
Recording, and these settings are valid for the other
pages as well.
The selected multisample or sample can be played
from the keyboard in any page, allowing you to hear
the results of your editing in each page.
Mode Page
Sampling Sampling P0: Recording
Combination Combination P0: Play– Audio Input/Sampling
Program Program P0: Play– Audio Input/Sampling
Sequencer
Sequencer P0: Play/REC– Preference, Audio
Input/Sampling
Page Explanation
P0: Recording
• Sampling and resampling
• Various settings for sampling
• Audio input settings
• Edit using the control surface
P1: Sample Edit • Sample waveform editing
P2: Loop Edit
• Sample playback parameter settings
• Start, loop start, and end address settings
• Loop and reverse playback on/off
• Editing operations such as Time Slice and
Time Stretch
P3: Multisample
Edit • Assign samples to multisamples, and
specify the zone and original key
P4: EQ/Control
ler • EQ adjustments for multisample playback
• Assign functions to controllers
P5: Audio CD
• Play back audio CDs
• Rip audio CDs
P6: ---
P7: ---
P8: Insert Effect
• Select and edit insert effects, adjust send
levels to the master effects, and specify
the routing to the outputs
P9: Master,
Total Effects • Select and edit master send effects and
total effects