KORG OASYS musical instruments - Manual (Page 108)

Creating songs (Sequencer mode)
100
Pan
This specifies the pan of audio track.
Volume
Sets the volume of audio tracks 1–16.
Recording procedure
Recording Setup
These parameters specify how audio tracks will be
recorded.
For details on each recording method, refer to the
examples for MIDI tracks. (See “Recording setup” on
page 85)
However, this differs from MIDI track recording as
follows.
Overwrite
When recording for the first time, you will normally
select this method.
To begin recording, press the SEQUENCER REC/
WRITE switch and then the SEQUENCER START/
STOP switch. To stop recording, press the
SEQUENCER START/STOP switch once again.
Audio Track Audio Events: Only the measures you
recorded will be overwritten; the data in subsequent
measures will remain unchanged.
Audio Track Automation Events: All data following
the measure at which you begin recording will be
erased.
Overdub
Select this method when you wish to add Audio Track
Automation Event data to a previously-recorded track.
To begin recording, press the SEQUENCER
REC/WRITE switch and then the SEQUENCER
START/STOP switch. To stop recording, press the
SEQUENCER START/STOP switch once again.
Audio Track Audio Events: As with Overwrite, only
the measures you recorded will be overwritten; the
data in subsequent measures will remain unchanged.
Audio Track Automation Events: The previously-
recorded data will remain, and the newly-recorded
data will be added to it.
Manual Punch In
Select this method when you wish to use the
SEQUENCER REC/WRITE switch or a foot switch to
re-record selected portions of a previously-recorded
track.
Auto Punch In
Select this method when you wish to automatically re-
record selected portions of a previously-recorded
track.
For both Manual Punch In and Auto Punch In,
recording will occur as follows.
Audio Track Audio Events, Audio Track Automation
Events: Only the measures you recorded will be
overwritten; the data in subsequent measures will
remain unchanged.
Loop All Tracks
Choose this method if you want to repeatedly record
track automation events over a specified region of
measures, adding data at each pass. Only automation
events can be recorded. You can use “Remove Data” to
remove audio track automation events.
Level Pan
Insert
Effects
CLIP !
Insert
Effects
L/R
Bus
REC
1,2,3,4
...
Indiv.
1,2,3,4,5,6,7,8
Sequencer Playback
Keyboard
Level Pan
Insert
Effects
Audio Input 1
Audio Input 2
REC Source = Audio Input 1
(Single Track REC)
Recording
Bus = L/R or IFX1-12
Bus = L/R or IFX1-12
Insert
Effects
Level Pan
HDR Track (Mono)
Audio Track selected in
Track Select
REC Source
Audio Input1
L/MONO
R
AUDIO OUTPUT
HEADPHONES
[x] Source Direct Solo
Total
Effects
Master
Effects Monitor