Konica Minolta IP-711 - Manual (Page 36)

4. Settings Required for Network Printing
27
17. Select “IP-711” created in step 12 from the “Defined printer” list and press
“Enter.”
18. Press “Insert” to display the “Available Queue” list of the printer.
19. Select the print queue prepared in step 4. Specify priority using a corresponding
number, 1 being the top priority and 10 being the lowest. Then, press “Enter” to
validate the selection.
20. Press “Esc” to quit Pconsole.
*
For the queue user rights, printer notification option, assignment of multiple
queues, and password, see the document available for NetWare and set them as
necessary.
21. Using Network Management Utility Light, set the controller as detailed below
and restart it.
Details of Setting:
Enable NetWare : Enable
Frame Type : Auto Detect (Select the frame type according to the
network environment.)
Bindery/NDS : Bindery
Print Server Name : Print server name created in step 7
Print Server Password : (Set only when the password is set on the NetWare
server side.)
Preferred File Server : Name of the file server to which PServer is
connected
Print Queue Scan Rate : 1 (Change as necessary.)
Mode : PServer
22. At the NetWare server console, load MONITOR.NLM.
23. Select “Connection Information” and check that the PServer created is
connected in the active connection column.
k4334P237CA