KTM 690 ENDURO EU - Manual (Page 123)

MAINTENANCE WORK ON CHASSIS AND ENGINE
121
100285-11
– Mount and tighten screws  .
Specification
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
– Mount the seat. ( P. 103)
9.65
Cooling system
600614-10
The water pump  in the engine forces the coolant to flow.
The pressure resulting from the warming of the cooling system is regulated by a valve in
the radiator cap
 . Heat expansion causes excess coolant to flow into the compensating
tank  . If the temperature falls, the excess coolant is sucked back into the cooling system.
The specified coolant temperature is therefore permissible without danger of function prob-
lems.
125 °C (257 °F)