Sierra Wireless RJ-11 - Manual (Page 13)

DocTitleHeader
8 2120028
Figure 2-2: Wireless Ace : PPP/Ethernet
4. When you have finished configuring the Ethernet settings,
click the Write button on the tool bar of Wireless Ace and
wait for the message “Write Successful” to appear in the
status bar.
Figure 2-3: Wireless Ace : Write
5. Note the IP address given to the modem by your cellular
provider.
a. Select Status from the menu on the left side of
Wireless Ace (under “Groups”).
Figure 2-4: Wireless Ace : Status (état)
b. Note the IP address listed in the Value column for the
command *NETIP.
For *NETSTATE, “Network Ready” means your modem is
connected on the cellular network and waiting for connections.
“Network Dormant” means the modem is connected and
waiting for connections but the connection has been idle. In
either state, the modem is ready for the steps in the next
section.
6. Disconnect your modem’s Ethernet cable from your
computer, but leave the modem connected to power so it
remains on the cellular network.