Sun Microsystems FASTETHERNET 6U - Manual (Page 57)

Chapter 3 Installing the Front-Access Adapter 39
3. During the power on sequence, watch the hot-swap LED on the adapter
( FIGURE 3-7 ).
■ The LED should blink quickly and then stay off if the adapter was installed
correctly.
■ If the hot-swap LED remains on (lit), the adapter was not installed correctly. The
adapter may not be seated correctly in the slot. You will need to remove and
reinstall the adapter using the cold-swap procedures to make sure that it sits
correctly in the slot:
■
Power off the server
■
Remove and replace the adapter
■
Power on the server
Refer to the server’s documentation for additional troubleshooting instructions.
4. Verify that the server’s power LED is on (lit), indicating that the server has
completely powered on.
Refer to the server’s documentation for the location of the power LED. For example,
on a Netra ct server, the power LED is on the front panel.