Sun Microsystems FASTETHERNET 6U - Manual (Page 53)

Chapter 3 Installing the Front-Access Adapter 35
For example, if the attachment point ID is pci_pci0:cpci_slot3 (the third
CompactPCI slot on the server), you would type:
The hot-swap LED should go off, indicating that the adapter has been activated.
14. Reattach the wrist strap to the chassis and to your wrist.
15. Using a No. 0 Phillips screwdriver, tighten the captive screws inside the adapter’s
top and bottom ejection levers.
The adapter may contain different types of ejection levers. For example, FIGURE 3-8
shows two possible types of levers.
FIGURE 3-8 Tightening the Ejection Lever Captive Screws (Two Types of Levers)
16. Remove the wrist strap from the chassis and from your wrist.
After installing the adapter, see “Connecting the Cables to the Front-Access
Adapter” on page 40 for instructions on connecting the cables to the front-access
adapter.
# cfgadm -c connect pci_pci0:cpci_slot3
# cfgadm -c configure pci_pci0:cpci_slot3