Siemens 1800C - Manual (Page 96)

10 - 4 R E M O T E F A X O P T I O N S ( N O T A V A I L A B L E F O R C O L O R F A X E S )
Remote Commands
Follow the commands below to access features remotely. When you call the fax
machine and enter your Remote Retrieval Access Code (1 5 9 ), the system
will signal you with two short beeps to enter a remote command.
Remote Commands Operation Details
95 Change Fax Forwarding
/Paging setting
1 OFF If you hear one long beep, the change is accepted. If you hear three
short beeps, you cannot change it because the conditions have not
been met (Example: registering paging number). You can register
your fax forwarding number by using 4. FAX FWD NO. (see page
10-5). Once you have registered the number, the fax machine will
change automatically to FAX FWD:ON mode.
2 Fax Forwarding
3 Paging
4 FAX FWD No.
6 Fax Storage ON You can turn FAX STORAGE to ON or OFF.
7 Fax Storage OFF
96 Retrieve a fax
2 Retrieve all faxes Enter the number of a remote fax machine to receive stored fax
message(s). (See page 10-5.)
3 Erase fax from the memory If you hear one long beep, you can erase fax message(s) from the
memory.
97 Check the Receiving Status
1 FAX You can check whether your fax machine has received any faxes.
If yes, you will hear one long beep. If no, you will hear three short
beeps.
98 Change Receive Mode
1 TAD: ANSWER MACH. If you hear one long beep, you can change the Receive Mode.
If you hear three short beeps, you cannot change it.
2 FAX/TEL
3 FAX ONLY
90 Exit After a long beep, you can exit remote retrieval.