Siemens 1800C - Manual (Page 71)

S E T U P S E N D 7 - 4
Color Fax Transmission
Your fax machine allows you to transmit a color fax.
1
Place the original face down in the ADF.
2
Enter the fax number using the dial pad, Speed Dial or Search.
3
Press Color Fax Start.
Manual and Automatic Fax Redial
If you’re sending a fax manually and the line is busy, press Redial/Pause to
try again. Anytime you want to make a second call to the last number dialed,
press Redial/Pause to save time.
If you’re sending a fax automatically and the line is busy, the fax machine will
automatically redial (up to three times at 5 minute intervals).
Dual Access (Not Available for Color Faxes)
You can scan up to 50 documents into the fax memory, even while the machine
is receiving or sending another fax (from memory). You can set temporary
settings for each fax you’re scanning, except Polling.
If you try to scan and store a 51st fax, the fax machine will send it immediately,
without storing it in memory.
1
Place the original face down in the ADF.
2
Enter the fax number.
3
Press Black Fax Start. The fax machine scans the original and the LCD shows
the job number (#XXX) of the fax and how much memory is available. Then the
fax machine starts dialing. You can immediately repeat Steps 1 to 3 for the next
fax.
When you are sending a color fax, the fax machine starts sending the fax
without scanning the original into memory.
Note
If you get a OUT OF MEMORY message while scanning the first page of a
fax, press Stop/Exit to cancel scanning. If you get a OUT OF MEMORY
message while scanning a subsequent page, you can press Black Fax Start to
transmit the pages scanned so far, or press Stop/Exit to cancel the operation.
Note
Your machine normally operates in Dual Access mode. However, to send a
color fax, you must override Dual Access and use Real Time Transmission.
The number of pages you can scan into memory varies with the data they
contain.