Sharp UX-470 - Manual (Page 49)

Transfer Function
The Transfer function is used to make the UX-470 automatically call
you at a specified number every time it receives an incoming message.
This lets you hear your messages immediately after they come in, even
when you are at a remote location.
When you answer the telephone, you will hear your recorded message
telling you that the call is a transfer call. Enter "#", your remote code
number, and "#". The answering machine will then play back your
messages. You can also perform any of the remote operations
described in the previous section.
Note: When you hang up after a transfer call, the UX-470 will not
immediately resume normal operation. If you want the UX-470 to accept
calls immediately after a transfer call, enter "
*" twice before hanging up
(if you want to hang up during message playback, first enter " 0" and " #"
to stop playback, then enter "
*" twice).
Programming the transfer number
To use the Transfer function, you must first give the UX-470 the
number to call (the transfer number). This is done by pressing the
panel keys as follows:
1
Press these keys:
0
FUNCTION
The display will show: A.M. SETTINGS
2
Press these keys:
The display will show: TRANSFER # ENTRY
2.
A
n
sw
e
ri
n
g
M
a
c
h
ine
Transfer Function
47