Sharp UX-470 - Manual (Page 18)

Telephone line cord
Insert one end of the line cord into the socket on the back of the
machine marked TEL. LINE. Insert the other end into a wall
telephone socket.
TEL.
SET TEL.
LINE
Be sure to insert the
telephone line cord into
the
TEL. LINE socket.
Do not insert it into the
TEL. SET socket.
Comments:
••
Your fax is set for tone dialling. If you are on a pulse only dial line, you must
set the fax for pulse dialling by changing Option Setting 9. This procedure is
described in Chapter 8, Option Settings.
••
If you are connecting the fax to a PBX, you may need to reset the fax to the
appropriate recall mode for the PBX. This is done by setting Option Setting
11 as described in Chapter 8.
••
If you intend to use a computer fax modem on the same phone line, you must
reset Option Setting 12 (Fax Signal Receive) to NO in order to prevent
transmission and reception errors. This procedure is described in Chapter 8,
Option Settings.
••
The facsimile machine will not ring in response to incoming calls and cannot
be used to make outgoing calls in the absence of mains power to the machine.
For this reason it is recommended that the fax is not left as the only telephone
instrument on line when in this state.
••
Your fax cannot be used on a key system without the necessary adaptation of
the system. Please consult the installers of the system if this is required.
Connections
16