Siemens SX1 - Manual (Page 71)

Setup
70
SX1 K1 en, A31008-H6500-A1-3-7619 (13. June 2003, 12:16)
© Siemens AG 2001, O:\Mobil\SX1_(K1)\en\k1gb_setup.fm
Connection
You need access points to
access the Internet for example to
• send/receive e-mails (p. 29)
• send/receive multimedia
messages (p. 28)
• use WAP applications (p. 42)
• activate modem operation
To connect to an access point, a data
connection is need. There may be ac-
cess points predefined by your pro-
vider. Otherwise your provider will
supply you with further information
on this.
C
K Setup K Settings K Connection
K Select a function:
Access points
A list of default or defined access
points may be shown. Select an ac-
cess point from the list or define a
new one.
New access point
OptionsKNew access point
Use default settings
If you want to use default entries.
Use existing settings
If you want to change an existing en-
try to create a new access point, se-
lect it from the list.
There are three types of connection
available:
GSM data call
Data transmission rate up to 14.4 kbps.
To configure this access point:
• Connection name: your choice
• Data bearer: GSM data
• Access point name: from provider
• User name: from provider if required
• Prompt password: choose Yes if you
want to key it in every logon
• Password: from provider if required
• Authentication: normal/Secure
• Gateway IP address: from provider
• Homepage: address of WAP service or
multimedia messaging centre
• Session mode: e.g. Permanent
• Connection security: from provider
• Data call type: analogue, ISDN v.110,
ISDN v. 120
• Maximum data speed: automatic, 9600,
14400,19200,28800
Note
You may receive the settings in a smart
message. If you save them, the received
settings are automatically used as Pre-
ferred connection , see Messages , p. 36.