Call, Setup – Siemens SX1 User Manual
Page 70
Setup
69
SX1 K1 en, A31008-H6500-A1-3-7619 (13. June 2003, 12:16)
© Siemens AG 2001, O:\Mobil\SX1_(K1)\en\k1gb_setup.fm
Call
C
K
Setup
K
Settings
K
Call
K
Select a function:
Send my caller ID
When you make a call, your phone
number can be displayed on the re-
cipient's display (depending on the
service providers).
Call waiting
During a call, you may be advised
that there is another call waiting.
You will hear a special tone during
the call. If you are registered for this
service, you can check whether it
is set and you can activate/deacti-
vate it.
Automatic redial
If busy, the number is automatically
dialled up to 10 times. End with:
E
End key.
Summary after call
Shows duration and costs of last calls
(needs activation of
Call cost limit
,
Shortcut
Switch function on/off (p. 87).
Anykey answer
You can press any key to accept an
incoming call.
Line in use
This function is only displayed if it is
supported by the service provider.
Two independent
phone numbers
must be registered on the phone.
Select the phone line you want for
daily use. Calls can be answered irre-
spective of the selected line.
0
Short
press to change left
softkey. Press softkey to
switch between the lines
in standby mode.
L
L
L