Sun Microsystems Gigabit Ethernet MMF/UTP Adapter User Manual

Page 80

Sun PCI-Express Dual Gigabit Ethernet MMF/UTP Adapter Installation and User’s Guide • June 2006

2. Modify the desired parameter using

TABLE 4-3

for available settings.

# 3 will set the 100 Mbps speed and half Duplex mode.

# 4 will set the 100 Mbps speed and Full Duplex mode.

# 7 will let adapter autonegotiate.

AutoNegAdvertised=0;

# This parameter determines the speed/duplex options that will be

# advertised during auto-negotiation. This is a bitmap with the

# following settings.

# Bit | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0

# Setting| N/A | N/A | 1000F | N/A | 100F | 100H | 10F | 10H

# For example:

# To advertise 10 Half only AutoNegAdvertised = 1

# To advertise 10 Full only AutoNegAdvertised = 2

# To advertise 10 Half/Full AutoNegAdvertised = 3

# To advertise 100 Half only AutoNegAdvertised = 4

# To advertise 100 Full only AutoNegAdvertised = 8

# To advertise 100 Half/Full AutoNegAdvertised = 12

# To advertise 1000 Full only AutoNegAdvertised = 32

# To advertise all speeds AutoNegAdvertised = 47

MaxFrameSize=0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0;

# 0 is for normal ethernet frames.

# 1 is for upto 4k size frames.

# 2 is for upto 8k size frames.

# 3 is for upto 16k size frames.

# These are maximum frame limits, not the actual ethernet frame

# size. Your actual ethernet frame size would be determined by

# protocol stack configuration (please refer to ndd command man pages)

# For Jumbo Frame Support (9k ethernet packet)

# use 3 (upto 16k size frames)

ProfileJumboTraffic=0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0;

# 0 is for not profiling Jumbo Traffic.

# 1 is for profiling Jumbo Traffic.

TbiCompatibilityEnable=1;

# 1 turns it on and 0 turns it off.

# Some switches as Cisco 6500/Foundary still operate in TBI mode.

# This setting will fix the problems seen with odd byte packets.

# This setting is valid only for 82543GC based copper adapters.

SetMasterSlave=0;

# 0 sets to hardware default

# 1 forces master

# 2 forces slave

# 3 forces auto

# This setting controls the PHY master/slave setting. Manually forcing

# master or slave can help reduce time to link with some switches

# (Planex 08TX and IO Data switches). It is recommended that this

# setting remain at the hardware default.