Sun Microsystems Gigabit Ethernet MMF/UTP Adapter User Manual

Page 108

Sun PCI-Express Dual Gigabit Ethernet MMF/UTP Adapter Installation and User’s Guide • June 2006

7. Use the test command and the device paths found in

to test the adapter

when you use the FCode self-test.

The structure of the test command line includes the following device parameters:

where:

s = 1000, 100, 10, auto
d = half, full, auto
c = master, slave, auto

Note –

The speed, duplex, and link-clock parameters are optional tests.

The following default tests are run when you execute the test command:

■

Tests six groups of Ophir registers (You can see the names of the six groups in the
output sample shown on the following page.)

■

Internal loopback test for the UTP card and external loopback test for the MMF
card.

■

10 Mbps PHY loopback.

Refer to the appropriate OpenBoot Command Reference Manual for more information
about the test command.

ok test

device-path:speed=s,duplex=d,link-clock=c,promiscuous,