Sun Microsystems Gigabit Ethernet MMF/UTP Adapter - Manual (Page 103)

69
A P P E N D I X
B
Diagnostic Software
This appendix provides an overview of the SunVTS™ diagnostic application and
instructions for updating the SunVTS software to recognize the adapter. This
appendix contains the following sections:
■ “SunVTS Diagnostic Software” on page 69
■ “Updating SunVTS to Recognize the Adapter” on page 70
■ “Using the SunVTS netlbtest” on page 71
■ “Using the OpenBoot PROM FCode Self-Test” on page 72
SunVTS Diagnostic Software
The SunVTS software executes multiple diagnostic hardware tests from a single user
interface and is used to verify the configuration and functionality of most hardware
controllers and devices. The SunVTS software operates primarily from a graphical
user interface, enabling test parameters to be set quickly and easily while a
diagnostic test operation is being performed.
Note – Ensure that you have SunVTS diagnostic software 6.2 or higher installed for
full support of Sun PCI-Express Dual Gigabit Ethernet adapters.
You can use the SunVTS nettest diagnostic to test all of the networking interfaces
on the system, including the interfaces on the adapter.
To use the nettest diagnostic, you must have the SunVTS software installed on
your system. Refer to your Solaris documentation for installation instructions.
Refer to the SunVTS documentation (listed in TABLE B-1 ) for instructions on how to
run and monitor the nettest diagnostic. These SunVTS documents are available
online at: