Sun Microsystems Gigabit Ethernet MMF/UTP Adapter - Manual (Page 69)

Chapter 3 Configuring ipge and e1000 Driver Parameters 35
TABLE 3-4 describes the parameters and settings for the ipge device driver.
TABLE 3-4 ipge Driver Parameter, Status, and Descriptions
Parameter Status Description
instance Read and write Device instance
adv-autoneg-cap Read and write Operational mode parameter
adv-1000fdx-cap Read and write Operational mode parameter
adv-1000hdx-cap Read and write Operational mode parameter
adv-100T4-cap Read and write Operational mode parameter
adv-100fdx-cap Read and write Operational mode parameter
adv-100hdx-cap Read and write Operational mode parameter
adv-10fdx-cap Read and write Operational mode parameter
adv-10hdx-cap Read and write Operational mode parameter
adv-asmpause-cap Read and write Flow control parameter
adv-pause-cap Read and write Flow control parameter
master-cfg-enable Read and write Gigabit link clock mastership controls
master-cfg-value Read and write Gigabit link clock mastership controls
use-int-xcvr Read only Use internal transceiver
enable-ipg0 Read and write Enable additional delay before transmitting a packet
ipg0 Read and write Additional delay before transmitting a packet
ipg1 Read and write Interpacket gap parameter
ipg2 Read and write Interpacket gap parameter
rx-intr-pkts Read and write Receive interrupt blanking values
rx-intr-time Read and write Receive interrupt blanking values
accept-jumbo Read and write Enable Jumbo Frames