Sun Microsystems Gigabit Ethernet MMF/UTP Adapter - Manual (Page 107)

Appendix B Diagnostic Software 73
4. Set the diag-switch? parameter to true in order to see the diagnostic power-on
self-test (POST) messages.
5. Reset the system to activate these parameter changes.
6. Use the show-nets command to display the list of network devices on the
system.
Among the list of devices, you should see the interfaces specific to the Sun PCI-
Express Dual Gigabit Ethernet Low-Profile adapter you want to test, as shown in the
following example.
Note – The preceding device paths are examples. The actual device paths on your
system might be different from the examples shown here.
ok setenv diag-switch? true
ok reset-all
ok show-nets
a) /pci@7c0/pci@0/pci@8/network@0,1
b) /pci@7c0/pci@0/pci@8/network@0
c) /pci@7c0/pci@0/pci@2/network@0,1
d) /pci@7c0/pci@0/pci@2/network@0
e) /pci@780/pci@0/pci@8/network@0,1
f) /pci@780/pci@0/pci@8/network@0
g) /pci@780/pci@0/pci@1/network@0,1
h) /pci@780/pci@0/pci@1/network@0
q) NO SELECTION
Enter Selection, q to quit: