Siemens Gigaset M49AM User Manual
Page 25
Gigaset M49AM user manual
25
Remote Access
This phone has remote access function. You can access it via other double-tone phones:
Put through to the answering machine,
After the Owner Message, enter remote access code,
The menu will be audibly played as:
The audio instructions for remote control
Press 2
Play the incoming messages
Press 2 again
Stop
Press 0
Erase the current message
Press 1
Backward
Press 3
Forward
Press 4
Activate or deactivate
Press 7
Play the functional table
How to deal with common failures
Phone
Question
Solution
No tone or pulse dialing signal
z Check if you have fit the phone cord into
the “Line” socket at the back of the base
and fit the other end into the phone line
socket on the wall.
z Be sure the power line of the base is
connected to the power socket.
z Unplug the phone cord of the base, then
insert the phone cord into another phone to
make sure if the same problem happens. If
so, it’s the problem of the phone cord or
phone service.
z Be sure the batteries are fully charged (16
hours).
z Check if the batteries are inserted correctly.
z The handset might be located too far away
from its range. Move it closer to the base.
z Press the Talk key on the handset to check
if there is dial tone and the indicator “In
Use” on the base lights. If not, the batteries
need charging.
z Place the handset back to the base for
another 20 seconds.
Can not make calls though with dialing signal
z Be sure to set correctly the tone or pulse
dialing.
No rings on handset/base
z Be sure to set the ring ON.
z The handset might be located too far away
from its range. Move it closer to the base.
z Check if you have installed too many
extensions. If so, unplug some.
Noise, or call interrupted
z The handset might be located too far away
from its range. Move it closer to the base.
z Relocate the base to avoid sharing power
sockets with other appliances.
z Place the handset back to its base to charge.
Dialing from stored caller-ID
z Did you enter the correct location code of
the stored number?
z Did you follow correct steps to dial the