Smart Inventions SMART Height-Adjustable Wall mount HAWM-UX/UF - Manual (Page 29)

24 | CHAPTER 3 – CABLING AN 880i4 OR 885i4 SYSTEM TO A HAWM-UX/UF
Placing cables for HAWM-UX/UF-mounted
components
To prevent cable friction, SMART recommends that you first place the cables that
don’t shift after they’re installed. Cables that connect components mounted to the
HAWM-UX/UF don’t shift after they’re installed. To prevent cable friction, SMART
recommends that you place these cables first.
Using the SMART UF65 and SMART UF65W projector
connection panel for HAWM-UX/UF mounted components
The following diagram and list identify the SMART UF65 and SMART UF65w projector
connections to HAWM-UX/UF-mounted components.
To access the projector connection panel and wire management clip, remove the
input/output cover on the left side of the projector and remove the cable covers. For
more information, see the SMART Board X800i4 Interactive Whiteboard System
Configuration and User’s Guide (
smarttech.com/kb/150699 ).
Number Function
1 4-pin power mini-DIN 5V/2A connector (reserved for ECP harness cable)
2 7-pin mini-DIN connector (reserved for ECP harness cable)
3 RCA jack composite video input (reserved for RCA pod)
4 RCA jack audio left/right input (reserved for RCA pod)
5 Audio 1 and Audio 2 (reserved for audio cable from pen tray)
6 3.5 mm audio output connector (recommended for SBA-L speakers)
7 DB9 control (reserved for ECP harness)
1 2 3 6 4 7 5