Sony SNC-RZ25P User Manual
Page 81
Ot
her
s
Using the SNMP
81
3)
sysName=
Set the case of “mib-2.system.sysName.0” in the
4)
enaAuthTraps=
Set the case value of “mib-2.snmp.snmp
EnableAuthenTraps.0” in the
Type “1” (enable) or “2” (disable) in the
position.
5) community=
Set the community name and the reading/writing
attributes.
number (1 to 8),
representing the reading/writing attribute (“r”, “R”,
“w or “W”),
community name to be set, and
describes the IP address of the host you allow
access (0.0.0.0 for any host).
Example: To allow reading/writing by any host in the
“private” community and having the ID number “2”.
community=2,w,private,0.0.0.0
6)
trap=
Set the host you want to send traps to.
describes the setting identification number (1 to 8),
name to send traps to, and
describes the IP address of the host to send traps to.
Example: To specify the destination of traps as the
private community and the ID number “1”.
trap=1,public,192.168.0.101
7)
delcommunity=
This parameter is used to delete the previous
community setting.
setting identification number (1 to 8).
8)
deltrap=
This parameter is used to delete the previous setting
of the host to send traps to.
setting identification number (1 to 8).
When you have finished changing the SNMP setting
information using the above parameters 1) to 8), check
the changed settings using an inquiry commands. If the
changed settings are OK, restart the SNMP using the
following CGI command.
SNMP restart command
GET, POST
http://ip_adr/snmpdconf/snmpdconf.cgi?
snmpd=restart