Sony SNC-RZ25P - Manual (Page 76)

Ot
her
s
Using the SNC panorama creator — Creating a Panorama Image
76
Main tab
Viewer
The created panorama image is displayed in the upper
viewer.
Angle setting
Set the view angle within the created 360-degree
panorama image.
Select the angle (degrees) from among 90 Deg, 180 Deg,
270 Deg or 360 Deg.
If you want to limit camera movement to the selected
view angle, check the Lock check box. The camera
moves only within the selected panorama view angle.
Note
The edges of the panorama image may not be displayed
correctly when the camera is zoomed in.
Make
Starts shooting to create a panorama image (a complete
360-degree panorama image). It takes about two
minutes to create a complete panorama image.
Note
The exposure and white balance settings are fixed while
a panorama image is being created. To create a clear
panorama image, set Exposure mode to Full auto and
White balance to Auto in the Camera menu and point
the camera to the main subject before starting shooting.
File open
Allows use of a Bitmap or JPEG image file in spite of a
panorama image.
Note
The size of the image in the file should be 320 × 90
pixels (horizontal/vertical). Other image sizes are not
supported.
Send
Transmits a panorama image converted into a JPEG file
to the camera.
Creating and transmitting a
panorama image
1
Click Make on the Main tab to start shooting.
A panorama image will be created in about two
minutes.
Note
Do not perform settings of the camera or move the
camera during shooting.
2
Select the view angle for a panorama image on
Angle Setting.
To limit the pan/tilt range of the camera to the
selected view angle, check the Lock check box.
3
Click Send to transmit the panorama image to the
camera.
The panorama image is saved in the camera.
You can use the saved panorama image when you
control panning and tilting from the main viewer.
Saving a custom image to the
camera
You can save a custom image to the camera in spite of
the panorama image shot by the camera.
Prepare the image to conform to the following
requirements:
• File format: JPEG or Bitmap
• Image size: 320 × 90 pixels (horizontal/vertical)
The camera does not support use of images that do not
conform to the above conditions.
1
Click File open on the Main tab.
The File dialog opens.
2
Select the image you have prepared.
3
Select the view angle of the image to be created in
Angle setting.
To limit the pan/tilt range of the camera to the
selected view angle, check the Lock check box.