Sanyo Multimedia PLC-XD2600 - Manual (Page 66)

66
Appendix
The image is distorted or runs off . – Check PC adjust menu or Screen menu and adjust them.
See pages 30-31, 34-35.
PIN code dialog box appears – PIN code lock is being set. Enter a PIN code (the “1234” or numbers
at start-up . you have set). See pages 19, 54-55.
The Remote Control does – Check the batteries.
not work . – Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4'(5 m).
– Make sure the code of the remote control is conformed to the
projector’s code. See page 53.
– Unlock the Key lock function for the remote control function. See
page 54.
Indicator blinks or lights . – Check the status of the projector with referring to "Indicators and
projector Condition". See page 70.
The exclamation mark appears – Your operation is invalid. Operate correctly.
on the screen .
Top control does not work . – The top control is not available if the top control is locked at Key lock
under Security of SETTING section. See page 54.
Unable to unlock the Logo PIN – Contact the dealer where you purchased the projector or the service
code lock, Security key lock center.
or Security PIN code lock .