Star Micronics Star SCP700 Series - Manual (Page 82)

78
3) N=2
n3 :Always “0”
(Default)
4) N=3 (Star mode only)
n1 :Always “0”
(Default)
5) N=4 (Star mode)
n2 :Always “0”
n3 :Always “0”
n4 :Always “0”
(Default)
Parameter Setting “0” “1” Remark
n1 Receipt printer ESC d
command
Receipt printer Cut Paper feed,
& Cut Star mode
only
n2 Receipt printer cutter Valid Invalid Star and
ESC/POS
n4 Receipt printer paper
near end Invalid Valid Star mode
only
Parameter Setting “0” “1” “2” “3”
n2 Character table (Code
page)
See belows
n3 Receipt printer printer
column 48 38 – –
n4 CR code Invalid Invalid Valid Valid
Receipt printer line feed
(mm) 4 3 4 3
n2 Code page n2 Code page n2 Code page n2 Code page
“0” Normal “3” 437 “6” 860 “9” 865
“1” katakana “4” 850 “7” 861 “A” 866
“2” 437 “5” 852 “8” 863
Parameter Setting “0” “1” “2” “3”
n1 X on/X off Timing When
Toggled every 3
sec When
Toggled every 3
sec
RTS Signal Condition Save as
DTR Save as
DTR always
SPACE always
SPACE