Star Micronics Star SCP700 Series User Manual

Page 55

“j”

Receipt printer: One time n/4-mm backfeed

Feeds the paper back n/4 mm only once after
printing the data in the line buffer. The space setting
for lines do not change. This command can also
feed the paper back to a previous page; however,
the position in the line on the previous page is
determined by the page length control.
The value of n is between 1 and 255.

Slip printer

: One time n/72-inch backfeed

Performs a line feed of n/72-inch only once after
printing the data in the line buffer. The space setting
for lines do not change. The value of n is between 1
and 255.

“3”

Set line spacing to n/216-inch
Sets the subsequent line spacing to n/216-inch.
The value of n is between 1 and 255.
Since the min. pitch of the slip paper feed mechanism is 1/144-inch,
the set value is approximated by the following formula
INT (n

2/3 + 0.5)/144 inch

This command is only valid with the slip printer

“y”

Set line spacing to n/144-inch
Sets the subsequent line spacing to n/144-inch.
The value of n is between 1 and 255.
This command is only valid with the slip printer

“I”

One time n/8 mm feed
Performs a line feed of n/8 mm only once after printing the data in
the line bufrer.
The space setting for lines does not change.
The value of n is between 1 and 255.
This command is only valid with the receipt printer.

CODE

HEX

FUNCTION

CODE

HEX

FUNCTION

CODE

HEX

FUNCTION

CODE

HEX

FUNCTION