Star Micronics Star SCP700 Series User Manual
Page 72

68
Slip Printer Control
n
1B
0F
n
Setting slip sensor
Sets the slip printer TOF/BOF sensor according to the value of n.
TOF Sensor
BOF Sensor
n = 00, “0” :
Valid
Valid
01, “1” :
Valid
Invalid
02, “2” :
Invalid
Valid
03, “3” :
Invalid
Invalid
Default values are:
n = 0 when memory switch 5-2 = 0 (factory setting)
n = 3 when memory switch 5-2 = 1
n
1B
0C
n
Slip function
After printing the data in the line buffer, operates the slip printer
according to the value of n.
n = 00, “0” :
Operates the clamp
01, “1” :
Releases the paper
02, “2” :
Releases the paper and waits until it is removed
03, “3” :
Feeds the paper backward (backfeed) until it
moves past the TOF sensor, then releases the
paper. (See NOTE below.)
04, “4” :
Feeds the paper into the printer (operational feed)
until it moves past the BOF sensor, then releases
the paper.
05, “5” :
Feeds the paper according to the direction and
length set by
released)
(NOTE) When the slip paper is attached to duplicates, a paper jam
may occur if the paper is always fed backward. Therefore,
the paper should not be ejected with n=3. To feed slip paper
attached to duplicates backward, use
the eject length to about half of the paper length, then eject
the paper using
This command is only valid with the slip printer.
CODE
HEX
FUNCTION
CODE
HEX
FUNCTION