Star Micronics Star SCP700 Series - Manual (Page 81)

77
“# N , n1n2n3n4”
1B 23 N 2C n1n2n3n4 0A 00
Set the memory switch. In order to enable changed memory switch
setting, turn the printer OFF and ON again or send printer reset
command ( “?””) to the printer. Changed
memory switch settings are stored in EEPROM and these setting will
be stored as long as the time when they are changed again.
N
:Memory switch number (“0”, “1”, “2”, “3”, “4”, “5”)
n1n2n3n4 :Mode settings (For details see below)
1) N=0 (Star mode only)
n1 :Always “0”
n3 :Always “0”
(Default)
(Default)
2) N=1 (Star mode only)
n1 :Always “0”
n2 :Always “0”
(Default)
Parameter Setting “0” “1”
n2 Customer display commands Valid Invalid
Parameter Setting “0” to “3” “4” to “7” “8” to “A” “B” to “F”
n4
Receipt FF command Form Feed Paper Feed,
Cut & Back
Form Feed Paper Feed,
Cut & Back
FF cut mode — Full-cut — Partial-cut
Parameter Setting “0” “1”
n3 Zero style Normal zero Slashed zero
n4 International character
set
See below
n4 Country n4 Country n4 Country n4 Country
“0” USA “3” UK “6” Italy “9” Norway
“1” France “4” Denmark #1 “7” Spain #1 “A” Denmark #2
“2” Germany “5” Sweden “8” Japan “B” Spain #2
n4 Country
“C” Latin America
CODE
HEX
FUNCTION