Sharp FO-IS115N - Manual (Page 132)

Messages and Signals
127
11
. T
roub
le-
shooting
FAX RX IN MEMORY A fax has been received in memory because the toner
cartridge needs replacement, you have run out of
printing paper, or the paper is jammed. Another
message will alternate with this message to indicate the
problem. The fax will print out automatically when the
problem is fixed.
HEATER HIGH /
HEATER LOW /
LASER ERROR If this message appears, unplug the power cord and
then plug it back in. If the message still appears, call for
service.
LINE ERROR Transmission or reception was not successful. Press
to clear the message and then try again. If the
error persists, see Line error on page 121.
M: xx% This shows the percentage of the machine’s memory
currently in use.
M#xxx This appears while a document is being scanned and
indicates the memory number assigned to the job (the
number appears in “xxx”). This number appears when
you check or cancel a job with the key (page 67).
MEMORY FULL If faxes have been received to memory because printing
is not possible, resolve the problem so that printing can
continue (see Reception to Memory on page 70).
If faxes are being held in memory because the Print
Hold function has been activated, print the faxes as
explained on page 89.
If you are attempting to broadcast or transmit from
memory, see If the memory becomes full on page 81.
If you are copying, see If MEMORY FULL appears on
page 79.
OUT OF PAPER /
PRINT CANCELED Printing was canceled because the tray is out of paper.
Press any key to clear the message, add paper, and
repeat the print job.
PAPER JAMMED The printing paper is jammed. See page 132.
PRT. HOLD DATA EXIST A received fax is being held in memory because the
Print Hold function has been activated. Enter your Print
Hold code to print the fax (see page 89).
STOP
INFO