Sharp FO-IS115N - Manual (Page 109)

Option Settings
104
NUMBER OF
RINGS This sets the number of rings on which the machine answers calls
when the reception mode is set to AUTO. Enter any number from
1 to 5.
Initial setting: 1 ring.
TRANSACTION
LIST This sets the condition for printing transaction reports (see page
110). Press a number key as follows:
(ALWAYS PRINT): Print after every fax transmission,
reception and error.
(ERROR/MEMORY): Print only after an error or memory
operation.
(SEND ONLY): Print after every fax transmission.
(ERROR ONLY): Print only when an error occurs.
(NEVER PRINT): Never print.
Initial setting: ERROR ONLY
FLASH
SELECT This setting is used when the machine is connected to a PBX and
the PBX uses the “Flash” method to connect to an outside line.
Press (SHORT TIME) if your PBX line is a normal line, or
(LONG TIME) if your PBX is a high-speed line.
Note: This setting is normally only used in Germany. In other
countries, you can try changing the setting if you encounter
difficulty with the default setting.
Initial setting: SHORT TIME
FAX SIGNAL
RX If you hear a soft fax tone after the machine rings and you answer
on the machine’s handset, the machine will automatically begin
reception. If desired, you can turn automatic reception off. Press
(YES) to turn on the the automatic reception function, or
(NO) to turn off the function. If you select NO, you must start
reception manually by pressing on the machine each time
you hear a soft fax tone after answering a call.
Initial setting: YES
START