Sharp FO-IS115N - Manual (Page 111)

Option Settings
106
PBX
CONNECTION If you are on a PBX, use this setting to set up automatic
connection to an outside line when dialing by automatic dialing.
(When this is done, unless you press the key before dialing
to dial manually, you will always automatically connect to an
outside line when you dial on the machine; there will be no need to
press the flash key ( ) or dial a prefix in order to dial out.)
1. Press (YES) to enable the PBX connection setting. (
(NO) should be selected if you are not on a PBX.)
2. Press (FLASH) if you connect to an outside line by
pressing a flash key ( on the machine). Press (ID) if you
connect to an outside line by dialing a particular number (a prefix
or ID number).
3. If you selected ID in step 2, enter the number that you dial to
connect to an outside line (maximum of 3 digits) and then press
.
DIAL TONE
DETECTION
Press (YES) to have the machine verify the presence of a
dial tone on the line before automatic dialling. Press (NO) to
turn this function off.
Note: If you select YES and find that the machine is unable to dial,
change the setting to NO.
Initial setting: NO
KEY TONE
Press (ON) to have the machine sound a beep each time a
key is pressed on the operation panel (this confirms that the key
has been correctly pressed). Press (OFF) to turn off the
beep sound.
Initial setting: ON
SPEAKER
R
R
START