Sun Microsystems eWay SAP BAPI User Manual
Page 21
Chapter 2
Section 2.3
Installing the eWay
Installing Enterprise Manager eWay Plug-Ins
eWay™ Adapter for SAP BAPI User’s Guide
21
Sun Microsystems, Inc.
Note:
An alert code is a warning that an error has occurred. It is not a diagnostic. The user
actions noted above are just some possible corrective measures you may take. Refer
to the log files for more information. For information on Managing and Monitoring
alert codes and logs, see the Sun SeeBeyond eGate Integrator System
Administration Guide.
SAPBAPI-CONNECT-CLIENT-
UP000003=
Alert to indicate that the SAP
JCO client is alive and valid.
If you are running in manual
mode, and this is an unexpected
state, check your collaboration
and verify all connect() calls;
otherwise, this Alert is only
informational.
SAPBAPI-CONNECT-CLIENT-
DOWN000004=
Alert to indicate that the SAP
JCO client is disconnected.
If you are running in manual
mode, and this is an unexpected
state, check your collaboration
and verify all disconnect() calls;
otherwise, this Alert is only
informational.
SAPBAPI-CONNECT-CLIENT-
RETRY000005=
Alert to indicate that the SAP
BAPI eWay is unable to
connect to SAP R/3 and is in
retry mode.
None
SAPBAPI-TIDFILE-
NOTAVAIL000006=
Alert to indicate that the TID
File is inaccessible.
Check that the directory for the
TID file exists and has write
permission for the user.
SAPBAPI-CONNECT-SERVER-
STARTED000007=
Alert to indicate that SAP JCO
Server is registered with SAP R/
3 and started.
None
SAPBAPI-CONNECT-SERVER-
STARTED-ERROR000008=
Alert to indicate that SAP JCO
Server could not be registered
with SAP R/3 and is not started.
The eWay is unable to register
with SAP as a server. Make sure
that the eWay is able to reach the
SAP system. Also check your SAP
BAPI External System values for
the Inbound SAP BAPI eWay. In
addition, check the SAP trace
logs.
SAPBAPI-CONNECT-SERVER-
STOPPED000009=
Alert to indicate that SAP JCO
Server was successfully
shutdown.
None
SAPBAPI-CONNECT-SERVER-
STOPPED-ERROR000010=
Alert to indicate that SAP JCO
Server could not be properly
shutdown.
Check your domain server.log
and the SAP trace logs for further
information.
SAPBAPI-RFC-
NOTPROCESSED-
ERROR000011=
Alert to indicate that an
incoming RFC Function was
not processed due to a failure
in the Collaboration or
Business Process.
Check your domain server.log
for further information.
Table 3
Alert Code\Description
Description Details
User Actions