Siemens Gigaset S450 - Manual (Page 38)

37
Using several handsets
Gigaset S450 / English for Greece / A31008-M1716-T101-1-8U19 / registr_sett.fm / 07.09.2005
Activating the room monitor and
entering the number to be called
v
¢
í
¢
Room Monitor
¤
Change multiple line input:
Room M.:
Select On to activate.
Call to:
Press the display key §Edit§ and enter
destination number.
External number: select number from
the directory or enter directly. Only the
last 4 digits are displayed.
Internal number: delete any stored
external number.
§INT§
s (select hand-
set or Call All , if all registered handsets
are to be called) §OK§ .
Store number with §Save§ .
Level:
Set noise level sensitivity ( Low or High ).
¤
Save changes (page 48).
The function is now activated. With v,
you can move directly to settings.
Changing previously set external
destination number
v
¢
í
¢
Room Monitor
s Scroll to the Call to: line.
§Edit§ Press the display key.
X Delete existing number.
¤
Enter number as described in
"Activating the room monitor and
entering the number to be called"
(page 37).
¤
Save changes (page 48).
Changing previously set internal
destination number
v
¢
í
¢
Room Monitor
s Scroll to the Call to: line.
§Edit§ Press the display key.
§Yes§ Press the display key to
confirm the prompt.
¤
Enter number as described in
"Activating the room monitor and
entering the number to be called"
(page 37).
¤
Save changes (page 48).
Deactivating the room monitor
remotely
Important: The phone must support
touch tone dialling and the room monitor
should be set for an external destination
number.
¤
Take the call from the room monitor
and press keys
9 ;.
The room monitor function will deactivate
after the call ends. There will be no further
room monitor calls. The other room
monitor settings on the handset (e.g. no
ringtone) will however remain activated
until you press the display key
§OFF§ on the
handset.
To reactivate the room function with the
same phone number:
¤
Turn on the activation again and save
(page 37) with
§Save§ .