Siemens Gigaset S450 - Manual (Page 37)

36
Using several handsets
Gigaset S450 / English for Greece / A31008-M1716-T101-1-8U19 / registr_sett.fm / 07.09.2005
Changing the name of a handset
The names "INT 1", "INT 2" etc. are
assigned automatically at registration.
You can change these names. The name
must be no more than 10 characters. The
changed name is displayed in every
handset's list.
u
Open list of handsets. Your
own handset is indicated by
< .
s Select handset.
§Edit§ Press the display key.
~ Enter name.
§Save§ Press the display key.
Changing a handset's internal
number
A handset is automatically assigned the
lowest unassigned number when it is
registered. If all the numbers have been
assigned, number 6 is overwritten,
provided the handset is in idle status. You
can change the internal number of all
registered handsets (1–6).
u
Open list of handsets. Your
own handset is indicated by
< .
v Open menu.
Edit H/Set No.
Select and press §OK§ . The list
of handsets is displayed.
s The current number flashes.
Select a handset.
~ Enter the new internal
number(1–6). The handset's
old number is overwritten.
§Save§ Press the display key to save
the input.
a Press and hold (idle status).
You will hear the error tone (descending
tone sequence) if you assign an internal
number twice.
¤
Repeat the process with an unused
number.
Using a handset as a room
monitor
If the room monitor is activated, a
previously stored destination number is
called as soon as a set noise level is
reached. You can store an internal or
external number in your handset as the
destination number.
The room monitor call to an external
number stops after approx. 90 seconds.
The room monitor call to an internal
number (handset) stops after approx. 3
minutes (depending on the base station).
While the room monitor is activated, all
keys are locked except the end call key.
The handset's speaker is muted.
When the room monitor is activated,
incoming calls to the handset are
indicated without a ringtone and are
only shown on the screen. The display
and keypad are not illuminated and
advisory tones are also turned off.
If you accept an incoming call, the room
monitor mode is suspended for the
duration of the call, but the function
remains activated.
If you switch off the handset, the room
monitor mode is deactivated. You must
reactivate the function after switching on
the handset again.
Caution!
– You should always check the operation
of the room monitor before use. For
example, test its sensitivity. Check the
connection if you are diverting the room
monitor to an outside number.
– When the function is switched on the
handset's operating time is severely
reduced. If necessary, place the handset in
the base. This ensures that the batteries do
not run down.
– Ideally the handset should be positioned 1
to 2 metres away from the baby. The
microphone must be directed towards the
baby.
– The connection to which the room monitor
is diverted must not be blocked by an
activated answering machine.