Sanyo SCP-7300 - Manual (Page 23)

End-of-Call Options
To display the following options, press within 10 seconds
after disconnecting a call.
To select an option, highlight it and press .
ᮣ Call Again to dial the phone number.
ᮣ Call:Speaker On to dial the phone number in speakerphone
mode.
ᮣ Save Phone# to save the phone number in your Contacts list.
Go to Phone Book appears when the number is already in your
Contacts list. (See “Saving a Phone Number” on this page.)
Note: The End-of-Call options are not displayed for calls identified as
No ID or Restricted.
Saving a Phone Number
Your phone can store up to seven phone numbers in each of
300 Contacts entries. Each entry’s name can contain 16 characters.
Your phone automatically sorts the Contacts entries alphabetically.
To save a number from the standby mode:
1. Enter a phone number.
2. Press .
3. Highlight Save Phone# and press .
4. Select a label by highlighting Home, Work, Mobile, Pager, Data,
Fax or No Label and press .
5. Enter a Name and press . (See “Selecting a Character
Input Mode” on page 18.) If you have already stored entries
in Contacts list, you are prompted to select the following
entry modes:
ᮣ New Name to enter a name directly.
ᮣ From Ph. Book to select a name from the Contacts entry list.
6. Press (left softkey). Save
15
7300 Bell_EN_3b.qxd 05.1.14 13:37 Page 15