Sun Microsystems StorageTek L40 - Manual (Page 82)

Configuration
A-6 Revision L 96053
■
Configuration
Three ways to configure the library to support SNMP are:
• Library Admin, an optional feature for the library, but it is not required to support
SNMP.
• The CLI port (command line interface)
See
Figure A-3 for examples of the help and help snmp commands.
• The SNMP software application—you can also use any SNMP application to change
some of the agent’s settings. You must be MIB-aware and refer to the L-series.mib for
specific information.
Figure A-3. CLI Help and Help SNMP Commands
cli> help
help [command] help on a specific command
diag execute diagnostics
download download new image to prom
fsc manipulate fault symptom codes
network manipulate network information
snmp manipulate SNMP configuration
time view/modify library date & time
password reset/modify library admin password
cli> help snmp
snmp view display SNMP Agent settings
snmp community [string] set Community String/IP address
snmp [enable|disable] enable of disable SNMP Agent
snmp port [port number] set Agent Listening Port Number
(Valid: 161, 1024-65535)
snmp grace [number] set Write Grace Period Number
( 1-5 minutes )
snmp reset set SNMP Agent configuration parameters
to default values
snmp list display SNMP Trap Recipient List
snmp add add a member to the SNMP Trap Recipient List by
answering individual prompts for values.
snmp add [ipaddr|name] add a member to the SNMP Trap Recipient List using
some default values
snmp add [ipaddr|name] [host port number]
add a member to the SNMP Trap Recipient List
using some default values
snmp delete [[ipaddr|name] [host port number]] | all
delete all or a selected member of the SNMP
Trap Recipient List
Where valid [host port number] values: (162, 1024-65535)
cli> _