Sun Microsystems StorageTek L40 - Manual (Page 61)

96053 Revision L 1-27
Standard Installation Procedure
CAUTION:
Possible component damage: Do not use a screwdriver for the drive door latch knob
or drive tray latch.
1. At the rear of the library, turn the drive door latch knob to your left to open the drive door.
1. Knob
CAUTION:
Load/unload problems: The drive tray latch must be fully loosened (disengaged)
before you slide the tray into the slot. If the latch arm contacts part of the library
frame as it is being tightened, it cannot be rotated to its fully locked position, and the
tray will not be firmly locked into the drive slot. This can cause alignment problems
and the camera can have problems reading the target.
2. Holding the drive tray assembly as shown in the figure below, turn the drive tray latch knob all the
way to your right so that it is in its fully disengaged position.
1. Knob
2. Range
3. Latch arm (shown disengaged)