Sun Microsystems StorageTek L40 - Manual (Page 22)

xx Revision L 96053
Each fiber-optic interface in this Sun StorageTek Fibre Channel equipment contains a
laser transceiver that is a Class 1 Laser Product. Each laser transceiver has an output of
less than 70 μW and a wavelength of 850 nm. Sun StorageTek’s Class 1 Laser Products
comply with EN60825-1(+A-11) and with sections 21 CFR 1040.10 and 1040.11 of the
Food and Drug Administration (FDA) regulations.
The following translations are for users in Finland and Sweden who wish to identify laser
safety and classification:
CLASS 1 LASER
LUOKAN 1 LASERLAITE
KLASSE 1 LASER APPARAT
Laser Product Label
In accordance with safety regulations, a label on each Sun StorageTek Fibre Channel
product identifies the laser class of the product and the place and date of the
manufacturer. The label appears on top of a Fibre Channel tape drive and near the Fibre
Channel connectors on a Fibre Channel tape library. A copy of the label is shown here:
Fiber-optic Cable Installation
Follow these guidelines when you install fiber-optic cables:
1. Cable routing:
• Raised floor: You may install fiber-optic cables under a raised floor. Route them
away from any obstruction, such as existing cables or other equipment.
• Cable tray or raceway: Place the cables in position; do not pull them through
the cable tray. Route the cables away from sharp corners, ceiling hangers, pipes,
and construction activity.
• Vertical rise length: Leave the cables on the shipping spool, and lower them
from above; do not pull the cables up from below. Use proper cable ties to
secure the cable.
• General: Do not install fiber-optic cables on top of smoke detectors.
CLASS 1 LASER PRODUCT
LASER KLASSE 1
APPAREIL A LASER DE CLASSE 1
COMPLIES WITH 21 CFR 1040.10 AND 1040.11