Sun Microsystems StorageTek L40 - Manual (Page 39)

96053 Revision L 1-5
Standard Installation Procedure
Preparing for the Installation
Read “Safety” on page xvii before beginning.
In general, for a successful installation you should be familiar with:
• SCSI principles (bus termination, terminating power, addressing)
• The SCSI cable plan for your installation
• The SCSI addresses (IDs) already in use by your system
• The SCSI IDs chosen for the devices to be installed (library and drives)
• Fibre Channel principles (termination, cabling, addressing) if your library includes an
optional Fibre Channel router
Unpacking the Library
Note: Save all the packing material in case you want to relocate or return the library in
the future.
Become familiar with the components in Figure 1-1 on page 1-6 , and:
1. Cut any packing tape, bands, and seals, and remove the outer container.
2. Remove the container locks.
3. Remove the container cap.
4. Remove the accessory container.
5. Remove the sleeve.
6. Remove the top cushion.
7. Remove the plastic bag.
8. Remove the front and rear rail of the bottom cushion. Do not remove the library from the
pallet.
9. Obtain the door key, part 419712101, from the accessory container, and unlock and
open the door.