Siemens 600Series - Manual (Page 84)

3-26 ROLMphone 300/600 Series User Guide
If you press a repdial key while you are on a call, Version 6.0
and 6.1 will place the first party on consultation hold before
dialing. To return to the first party, press the Connect key.
To set up a
repdial key ➩ Press the Program key. The Program status
light turns on. If you have a display
telephone, PRESS FEATURE KEY OR
DIAL CODE is displayed.
➩ Press the repdial (R-) key you want to set
up. If you have a display telephone,
REPDIAL is displayed, followed by either
the dialing sequence or NOTHING
STORED. NEW NUMBER is then
displayed.
➩ Enter the dialing sequence you want to
assign to the R- key. If you make an error
while entering the dialing sequence, press
the Clear key to cancel your changes. Then
enter the sequence again.
➩ If you want to set up another R- key, press
the Store key. If you have a display
telephone, STORED is displayed. Repeat
the two previous steps.
➩ To end setup, press the Program key. The
Program status light turns off. If you have
a display telephone, STORED is displayed.
➩ On your faceplate, use a pencil to label
each R- key you changed with the name of
the feature or person it dials.